Hard question, Comparing thermal enegy and photo cell watt’s.
Using the idea of a magnifing class and a lense to straighting it into a lazer.
If I were to hit a heat sink or something laying in water, would I be able to transfer more thermal energy into the water then a photo could by powering a hot plate? Assume the size of the maginifing lense is the same amount of area as the photo cells?
Tagged cell, enegy, energy, Hard, photo, photo cell, question, thermal enegy, Watt
How would you compute the amp/watt demand by the hour for a house wired 110/120 volt? Looking to install a wind generator for the retirement home and would like to be off the grid. House would have basically all modern appliances, air and heat plus would probably run a pump for the well. More than likely there would also be a couple out buildings to be powered.
Thank you.
Posted in Water Power
Tagged amp, appliances, DEMAND, electrical demand, generator, home, hour, HOUSE, retirement, retirement home, volt, Watt, wind, wind generator
The generator is powered by wind, but I am having a hard time converting the 10 volts shown on a meter to watts produced. Help would be very much appreciated. Also, once converted to DC do the watts output remain the same? A formula would be ideal. Thanks.
Posted in Water Power
Tagged ac power, Formula, generator, hard time, meter, output, power, power generator, time, volts, Watt, watt output, Watts, wind
I have a 6500 watt Honda generator with a burnt up armature. I will be forced to rewind. This will not pose a problem as I have a large back geared lathe. The problem is the winding was overheated so severly that it was fused togather. I had to cut it off so I was unable to count the turns, However Only one side was burnt. The other side is in good shape so I still have a good winding for reference. I need to determine the number of wraps in the winding and do not wish to unwind the good side for a count. Is it possible to measure the resistance on the good side and wrap the other side till I get the same amount? do I have to induce a known voltage in the good side and check it another way? What is the easiest way to determine the correct number of turns without unwinding the undamaged side? I could sure use some help on this one!
Posted in Water Power
Tagged armature, generator, good shape, Honda, honda generator, lathe, number, problem, resistance, rewind, side, Watt, watt honda, way, wraps
Affordable wind turbines 300 watt micro helical vertical axis wind turbine phone 361-444-3711 or 563-570-6239
Video Rating: 0 / 5
Posted in Wind Power
Tagged affordable, AXIS, Helical, Micro, turbine, turbines, vertical, Watt, wind
WG400 GudCraft 400W Wind Generator is a low wind speed, small-size wind generator with starting speed just 5mph or more.
List Price: $ 399.00
Price: [wpramaprice asin="B004Z8IQF4"]
[wpramareviews asin="B004Z8IQF4"]
Posted in Wind Power
Tagged 12Volt, 6Blade, charge, controller, generator, GudCraft, Watt, WG400X, wind
Sun Powered
No Wiring
Powered by the sun
Fast & easy install
Energy, electrical saving
Recharged by solar panel under sunlight
Corrosion resistant
CE certified
This solar powered water pump is designed for fountains, ponds or other outdoor use.
has the ability to work during the night.
With the battery pack attached, a full charge during the day can provide up to an additional 4 hours of operation.
This solar powered pump also comes with a manual on/off switch.
This uses Lead Acid 6V-4AH rechargeable batteries.
Solar Panel Dimension: 15×16
Operation Pump Voltage 12V-20V
Soalr Module 8W
Water Lift Max 2M
Water Flow Max 800L/H
LED light (voltage) DC12V
Disclosure: All solar products are not to be used with non-rechargeable batteries. Doing so may cause unrepairable damage to the unit.
List Price: $ 103.50
Price: [wpramaprice asin="B0037ANZKW"]
[wpramareviews asin="B0037ANZKW"]
[wprebay kw="solar+pump" num="20" ebcat="-1"] [wprebay kw="solar+pump" num="21" ebcat="-1"]
Related Solar Pump Products